Ever wondered what your Amiga is doing when all those lights flicker on and off in a scary fashion. The Amiga may look like its doing nothing when you switch on your machine then you will probably be right. No, damn. I mean that it's doing loads of selftest things to see if the system is well. The list below shows the normal checks that a standard 68000 A500 performs:
Clears all memory of old data.
Disables DMA and interrupts during the selftest.
Clears the screen.
Checks the processor is working.
Changes the screen colour.
Do a checksum test in the ROM.
Changes the screen colour, again.
Begins the system startup.
Checks RAM at address and moves SYSBASE there.
Test all Chip ram.
Changes the screen colour, AGAIN.
Checks that the software is being executed.
Changes the screen colour, for a laugh.
Sets the Chip ram to be accessed.
Links the libraries.
Checks for fast ram.
Turns the DMA and interrupts on.
Starts a default task.
Checks for an accelerator or a maths coprocessor.
Checks the processor again to see if there is an error.
If an error is found the system is reset.
Whilst the selftest is being carried out information is being displayed. This is shown through the screen changes that are mentioned in points 3, 7, 11, and 13. If all of the tests have been passed, you will see the following colour sequence.
Dark Grey: The hardware test has been completed OK, and the registers are readable.
Light Grey: The software side has passed.
White: The initialisation is correct and the system is ready to boot.
If there is something wrong with your system you may see the following colours.
Red: An error was found in the ROM.
Green: An error was found in Chip ram.
Blue: An error was found in the custom chips.
Yellow: The CPU has found an error before the error trapping software (Guru) has been activated.
These problems could be caused by a number of things such as a loose chip or board. The red screen may be caused by a loose Kickstart chip that can be fixed by pressing down on the ROM to check it is fitted correctly. Another cause could be a connection problems between the chip and socket that can be solved by straightening an bent pins. Alternatively, the green screen could be caused by a loose memory board, SIMM, or a loose RAM chip on the memory board. If reattaching these chips do not solve the problem, try them on another Amiga.
The keyboard also has its own processor, RAM, and ROM. It also has a selftest that performed on power up in the following sequence.
Performs a checksum on the ROM.
Checks the 64 bytes of keyboard RAM.
The timer is being tested
Performs a handshake with the computer and gives the result of the selftest.
If the keyboard does not pass the test, it will tell you through the blinking of the caps lock light.
One blink: Keyboard ROM check failed.
Two blinks: Keyboard RAM check failed.
Three blinks: Watch dog timer failure.
Four blinks: A short between two lines or the special control keys.
READ THIS (please). Don't panic if your keyboard flashes once when you switch on. THIS IS PERFECTLY NORMAL. Every Amiga in the entire universe does this.